Skip to product information
DS-120 прозрачен запечатващ лак за бетонови настилки, бидон

DS-120 – solvent-based clear coating for flooring surfaces

При запитване
Реф. номер DS-120
25 kg canister · Coverage rate: 200–250 g/m² · Coverage: ~111 m²
В наличност

Transparent solvent-based gloss sealer for stamped concrete and stone.
Seals, protects and dustproofs the surface.
Coverage: 200–250 g/m². 25 kg container.

PackagingCanister, 25 kg
Колко квадрата ще покриваш?
м²

Изчислението е ориентировъчно и се закръгля нагоре до цяла опаковка.

Цената е при запитване. Или се обади: +359 879 112 284

  • Cash on delivery
  • Delivery within 1–3 business days
  • Returns within 14 days

DS-120 is a clear varnish based on high-quality special resins, designed to protectively seal stamped concrete, natural stone and similar surfaces. It is applied as a final coat to concrete slabs, sealing and protecting them while slowing wear. It also acts as a dustproof coating.

The product is part of the manufacturer’s solvent-based range (aromatic hydrocarbon solvents) and is applied undiluted. It forms a glossy, waterproof film with excellent adhesion that is resistant to abrasion, weathering, alkalis and fats, and enhances the appearance of the paving. Compared with DS-90, it has a higher solids content (36 ± 1%) and a shelf life of 12 months.

It is used on stamped concrete made with Colorcem Impreso or Colorcem 1 cm, after curing for at least 28 days and after Desmoldeante P release agent has been completely removed and the surface has dried. The film does not allow water vapor to pass through, so a vapor barrier must be installed before concreting. Light colors may yellow slightly; to avoid this, the manufacturer recommends MS-83, which is also the specifically recommended varnish for areas subject to vehicle traffic and for parking lots.

DS-120 is used as a protective final layer on concrete and stone pavements.

  • Stamped concrete
  • Concrete slabs, as a sealing and dust-proof coating
  • Stone pavements

Consumption

Consumption 200–250 g/m².

Packaging

25 kg drums. Pallet of 24 drums.

1. Before pouring the concrete, lay polyethylene sheeting (400 gauge) over the base, extending it up the sides, as a vapor barrier. This step is mandatory.

2. Allow at least 28 days for the concrete to cure fully.

3. Use a moisture meter to check several points and confirm that the surface moisture is below 4%. Washing with Desmoldeante P dampens the surface, so wait for it to dry again until it is below this level.

4. The surface must be dry and free of dust, grease, dirt, and anything else that could impair adhesion. No more than 3% release-agent residue is permitted.

5. Ensure maximum ventilation during application to speed up drying and avoid inhaling the vapors.

6. Apply the product directly, without adding solvents, using a sprayer to form an even film without thick layers. Suitable methods include an airless spray gun, an air spray gun, a brush, or a roller.

7. Once the first coat has dried, a second coat may be applied if desired, taking care not to apply excess product, including in the joints.

8. Clean the tools with a universal solvent.

Reference|DS-120
Base|Solvent-based, special resins
Appearance|Glossy
Color|Transparent
Density|0.93 ± 0.01 g/cm³
Drying time|1–2 hours
Solids content (by weight)|36 ± 1%
Coverage|200–250 g/m²
Application temperature|+5 to +30 °C
Substrate moisture|below 4%
The values are indicative and depend on site conditions.

Storage

In the original, sealed packaging, protected from the elements. Shelf life: 12 months from the date of manufacture when stored correctly.

Precautions

  • Read the safety data sheet before use.
  • Work in well-ventilated areas and avoid inhaling vapours.
  • Use appropriate personal protective equipment to prevent skin contact.
  • Application temperature: +5 to +30 °C. Do not apply if frost is expected or after prolonged exposure to strong sunlight.
  • With light colours, the varnish may turn slightly yellow over time and when exposed to sunlight.

Used together with

Frequently Asked Questions

Най-честите въпроси за доставката, плащането и работата с материалите. Не намираш отговор? Обади се на +359 879 112 284.

Всеки продукт има посочен разход на квадратен метър и покритие на опаковка. На страницата на продукта има калкулатор: въвеждаш площта и той пресмята колко опаковки са нужни и попълва количеството в запитването.

При по-голям обект или сложна основа ни се обади, правим точна сметка безплатно.

Да. „ВЕРТИГО СК" ЕООД е официален дистрибутор за България на испанския производител Morteros Henares. Всички материали идват директно от завода, с оригинални опаковки и придружаващи документи: техническа карта, информационен лист за безопасност и декларация за експлоатационни показатели.

Да, доставяме до всяко населено място в България с куриер.

  • Отделни торби и кофи: обикновено 1-3 работни дни.
  • Палети и по-големи количества: 3-5 работни дни, с предварително уговорен ден.

Срокът започва да тече от потвърждаването на поръчката. Подробностите са в условията за доставка.

Да. Плащаш на куриера при получаване на пратката. Приемаме и банков превод, удобно е за фирми и за по-големи количества, защото фактурата излиза веднага.

Да. Ако ти трябва фактура на фирма, напиши данните в полето за бележки при поръчката или ни пиши на lubomire73@gmail.com. Издаваме фактурата към поръчката и я изпращаме по имейл.

Цветовете в картата са ориентировъчни. Крайният тон зависи от цвета на бетона под материала, от влажността при полагане, от дълбочината на текстурата и от запечатващия лак.

Затова винаги поръчвай целия материал за един обект наведнъж и по възможност от една партида, така тонът е еднакъв по цялата площ.

За щампован бетон са нужни три неща: цветна посипка, отделител (за да не залепва щампата) и запечатващ лак накрая. Щампите се наемат или купуват отделно.

Използвай калкулатора „Колко материал ти трябва?". Той изчислява количествата за цялата система, а не само за един продукт.

Да. За палетни количества и за обекти работим с отделни цени. Пиши ни площта на обекта и желаните цветове през формата за контакт или се обади на +359 879 112 284, връщаме оферта до един работен ден.

Да, имаш 14 дни да се откажеш от поръчката без да посочваш причина. Материалът трябва да е в оригинална неотворена опаковка и в търговски вид.

Целият ред е описан в Връщане и замяна.

Да, безплатно. Обади се на +359 879 112 284 в работно време (понеделник - петък, 08:00-18:00 ч.) и опиши обекта: какъв е бетонът, каква площ, на закрито или на открито. Ще ти кажем кои материали са правилните и в какво количество.

Not sure what you need?

Call or write to us. We can help you choose a system and work out the quantities before you order.

Monday–Friday, 08:00–18:00 h.